making a pendent for my daughter.
rolled out the PMC 3 clay to the approximate size of the leaf.
Placed the leaf on top of the clay…
then I rolled over the leaf on top of the PMC to embed the veins/pattern.
when it was slightly dry, I pulled off the leaf.
I’m adding small pieces to where the leaf tips are to make them stronger.

PMC Maple Leaf

This is a big pendent 2.5″HX3 ” …

I’ve propped up the leaf tips while it dries to give it dimension.
the cabochon will go in the center… either a bezel or I’ll wire wrap it in place.

I plan to enamel it – just a dusting
may use copper wire for the bails and wire enclosure for the stone.

working it out as I go…